Minneapolis MN Cars & Cafe, Saturday August 1st 8am-11am (Dyno Day and Tuning after)
#1
Minneapolis MN Cars & Cafe, Saturday August 1st 8am-11am (Dyno Day and Tuning after)


Hey guys,
Last month brought us anther back to back rainy event. Despite the weather, we had close to 200 very special cars in attendance.
This month we will have some better weather and a couple of special events afterwards.
Immediately after our event, we will be holding a Dyno shoot out at APS in Shakopee. (3136 130th St. W Shakopee MN 55379). $40 for 3 pulls on their 2wd Dynojet. There will be food, drink and music at APS.
We are also very happy to announce that Todd Zuccone from Evolution Motorsports in Tempe AZ ( www.evoms.com ) will be there joining us and tuning european cars with their own Evomsit software. Check their website for your application and pricing ( EVOMSit Intelligent Tuning ) Evolution Motorsports will be prividing a 10% discount off all tuning during this weekend. Please contact me for more details/reservations.
Please note that our event is from 8-11am. Parking is first come first serve. If you show up at 10:45, the lot is more than likely going to be full and you will be asked to park in general parking.
Unless you are looking to get this event shut down, please keep the burnouts and hard launches for the track.
Time and Location:
The event is from 8am-11am
The location is the Minneapolis AutoMotorplex located at:
1740 Motorplex Ct. Chanhassen MN
Please check out the Motorplex’s website for map and other details: AutoMotorPlex - MPLS
For people traveling east of 494 we would encourage you to take the Crosstown (62) extension (HWY 5) the where it becomes 212, exit on Powers Blvd (Which is 1 exit past 101) go right, drive approx 500 ft and turn left on Lyman (at the light) travel approximately 1 mile, turn right on Audubon and we will be 1.1 mile on the left.
Please mark your calendars with the following dates:
September 5th
October 3rd
Parking map:

Pics from Last month: (Thanks Alex)







Video from Last Month: (Thanks Matt)
Cars & Café MN July 2009 on Vimeo
See you guys there!!!
Picasa Web Albums - Alex - Cars & Cafe 7...
#2
Cool vid! I'll definitely be there! AutoMotorPlex has really grown into an automotive playground. Such a great facility for C&C!
Thanks for all your hard work putting all of this together, Luis.
BTW, let me know if there is some dyno tuning going on on Friday when Todd is in town so I can work it into my schedule.
Thanks for all your hard work putting all of this together, Luis.
BTW, let me know if there is some dyno tuning going on on Friday when Todd is in town so I can work it into my schedule.
#5
Pics!!!!









1 of 2 Ferrari 250 GT SWB coupes that showed up. This one was built in 1962, iirc.

The other Ferrari 250 GT SWB coupe. This was built in 1959.







Probably my favorite shot of the morning.












1 of 2 Ferrari 250 GT SWB coupes that showed up. This one was built in 1962, iirc.

The other Ferrari 250 GT SWB coupe. This was built in 1959.







Probably my favorite shot of the morning.



Last edited by Alzilla; Aug 2, 2009 at 03:24 PM.
#7



The M3s after having a few chances on the dyno






AtomicZ's badass track prepped C6 Z06



The only good shot I got of my dad's Camaro Z28 during its maiden dyno run. It made 320 rwhp and 335 lb-ft exactly on both pulls with just a catback exhaust and K&N filter, not even tuned. I was pretty happy that it beat all of the naturally aspirated M3s!

A quick M3cs photoshoot






A quick Bentley Continental CGT Speed photoshoot as well





As usual, more pics can be seen in my gallery HERE.
#9
Thanks Luis! I had a blast up there!
I don't think you were at APS when I ran the Camaro on the dyno but it put down 320 whp and 335 lb-ft of torque with just a K&N filter and a catback exhaust without even being tuned. Not bad, right?
I don't think you were at APS when I ran the Camaro on the dyno but it put down 320 whp and 335 lb-ft of torque with just a K&N filter and a catback exhaust without even being tuned. Not bad, right?





I'll give you a call and give you more details. 















