2012 Volkswagen Golf R Detail With AQuartz
#1
06-06-2012, 12:55 PM
2012 Volkswagen Golf R Detail With AQuartz
Just completed in the shop, this Golf R is brand new and the owner wanted the best clarity and shine along with a coating to give him the best protection as well. The vehicle did not need massive correction but there were a few deep RIDS and some marring especially on the "B-pillars" with the supersoft paint.
Before the wash/decon steps.
B-pillars under led light.
After the wash, the pillars stripped of any LSP, they were marred a good amount.
After compounding/medium polishing steps.
Drivers side pillars not looking too good either.
After.
Topside of the rear bumper had some RIDS, and slight marring after clay step.
After.
Paint overall was "As new" but there were a few deep RIDS like these.
After a little effort, correction was achieved and the readings were healthy for the finish still(134microns).
All finished.
Interior just needed a Vac/wipedown.
Nice touch......embossed "R" logo.
Finished Sun pics.
Before the wash/decon steps.
B-pillars under led light.
After the wash, the pillars stripped of any LSP, they were marred a good amount.
After compounding/medium polishing steps.
Drivers side pillars not looking too good either.
After.
Topside of the rear bumper had some RIDS, and slight marring after clay step.
After.
Paint overall was "As new" but there were a few deep RIDS like these.
After a little effort, correction was achieved and the readings were healthy for the finish still(134microns).
All finished.
Interior just needed a Vac/wipedown.
Nice touch......embossed "R" logo.
Finished Sun pics.
#2
06-06-2012, 12:57 PM
Client snapping pics on his phone to show his girfriend at home, he was a "Happy camper".
CERTIFIED TIGTNESS.
Thread
Thread Starter
Forum
Replies
Last Post
Auto Concierge
Detailing & Paint Protection
1
04-26-2013 01:39 PM
Auto Concierge
Detailing & Paint Protection
1
03-23-2012 06:27 PM
DJ
General Automotive & SUV Forum
9
12-10-2010 03:40 PM
Bookmarks
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)